Borg Warner R10-R11 Overdrive 12 volt Complete Kit
Borg Warner R-10 R-11 Overdrive 12 volt Complete Electrical Kit
This kit includes all the NEW 12 volt electrical components and control cable in the overdrive system.
- 12 volt New Solenoid and new seal
- 12 volt New Relay
- 12 volt New Kick down Switch
- 12 volt New Wire Harness (7 ft long between the relay and the solenoid + 12" for lockout sw)
- New Control Cable (Does not include dash bracket)
- Governor rubber cover
The Solenoid will only fit standard Borg Warner R10 R11 overdrive applications with a shaft length of 1", measured from the tip of the shaft to the edge of the alignment flange. (lay your ruler on top of the shaft and measure from the ball end to the edge of the casting.) Refer to picture. All standard overdrive-solenoids will measure 1". Station Wagons and convertibles will measure 1.5 inches and a few odd applications will measure 1.25 inches or longer. There are no long shaft solenoids available.
New 12 volt Relay is in a watertight metal container and is simple to install with screw strip.
Wire harness is 7' long to reach from relay, kick down switch, solenoid and lockout sw.
2 Reviews Hide Reviews Show Reviews
I have it on the car and the overdrive is working.. I have been very happy with my dealing with Vintage Auto Garage. Thanks again, Peter
Parts that I ordered from vintage Auto fit right & was shipped on time. I'm on the road again & vehicle is operating well! So I would suggest Vintage Auto if you want be on the road again.